Do you dream of an exquisite floor? Are you inspired by beauty and
seek exceptional quality with practical appeal? Then Wood Flooring
is the answer to your dreams since you were also looking for install hard wood floor.
Natural wood under your feet. Hardwood or bamboo flooring in
your home reflects a personal image and is a major design feature.
There is a wide range of styles available to reflect your individuality
so, you can have a floor that compliments the interior design
chic of tomorrow and bring a comfortable atmothsphere into your
Hardwood and Bamboo flooring will add warmth to your home and
because it has a natural grain, each floor is unique, allowing
your home to stand out from the rest.
Hardwood and bamboo flooring is hardwearing and durable and very
easy to maintain, any spills are easily wiped up and you would
never even know they happened.
Laying your hardwood or bamboo flooring could not be easier!
There are a few tools that will come in handy like a pair of
scissors or a knife, try square, pencil. ruler, dust mask, hardpoint
handsaw or jigsaw, fitting wedges and trim cutters.
Below is a step by step guide to laying "click" style
hardwood or bamboo flooring.
1. Lay the boards lengthways towards the light source. Use fitting
wedges at intervals between the board and skirting. You should
leave a 10mm gap between your flooring and the skirting for expansion.
Lay the first board in a left hand corner, the end with the short
tongue against the wall. Lay the next board end on, placing the
short tongue of the second board into the long tongue of the first
board at a 30 degree angle. Lower the board and lock it into place.
Lay more boards in the same way until you reach the end of the
row, where you will probably have to cut a board to make it fit.
If the cut off piece is 300mm-900mm use it to start the next row,
otherwise halve a new board, as the joined should be staggered.
2. To star the next row, angle the cut board against the board
in the previous row, cut end next to the skirting wedge. Press
forward and fold down at the same time to lock its long side.
Place the short end of the next board at an angle against the
previous board and fold down. making sure the board is on the
locking strip in the previous row. Angle the boards by 30 degrees
and push them against the row in front. When the boards are tightly
together, push them down. Continue to lay the boards in this way
row by row.
3.For the last row, place a board on top of the second last row
and place a third board on top with the tongue touching the skirting
and use the edge to mark the cutting line on the board beneath.
Cut the board and ease it into position, Remove the wedges.
4. Once the flooring is laid cover the edge around the edge or
the room with flooring trim or skirting. The trim or skirting
should be fixed to the original skirting -NOT to the floor- with
adhesive. Use trim cutters that cut the trim in a straight line
or at an angle to fit in the corner.
When buying your hardwood or bamboo flooring don't forget to
buy the accessories that make the finishing touches to your perfect
You will need underlay, there are many different types and depending
on where you are laying your hardwood or bamboo flooring you will
need to get the type to suit the conditions.
There is also a damp proof membrane available to ensure that
no damp gets through to your hardwood or bamboo flooring.
A stunning floor deserves a stunning finish, so choose your trims
that guarantee a seamless transition from floor to wall.
When your hardwood or bamboo flooring stops and the flooring
of another room start there are door bars that can be used to
gracefully take you through into the next room.
And for the perfectionist there are pipe covers that hide the
expansion cap around your pipes.
All in all hardwood and bamboo flooring are amongst the most
hardwearing durable and hassle free type of flooring available.
And with so many styles to choose from there is something for
Click the arrows below to scroll through the complete style ranges
If you need assistance with finding someone to install your hardwood
or bamboo flooring then Reliable Remodeler will be able to put
you in contact with a pre-qualified fitter who will be able to
help you. Simply click on the banner below to get your three FREE
estimates from pre-qualified, pre-screened, licenced and insured
Hardwood Floor Care Will Keep Your Hardwood Looking Fantastic
Hardwood is still the homeowner’s favorite choice of flooring
and caring for it takes minimal effort.
Unlike laminate or engineered wood, hardwood can be refinished
many times, and will add years of beauty and warmth to your home,
as well as increase its value and speed its resale.
Ongoing floor care is needed to keep your hardwood looking its
best, however, and there are four major aspects of hardwood floor
1. Hardwood floor cleaning
2. Hardwood floor repair
3. Hardwood floor refinishing
4. Hardwood floor protection
Clean Your Hardwood Regularly Knowing how to clean hardwood floors
is important because the bane of hardwood is dirt and grit, which
will scratch and mark the floor if not removed promptly.
As well, dust is seen more easily on wood floors than it is
on linoleum or on carpet, especially in the sunlight and especially
if the floor has a dark stain.
Hardwood floor care, therefore, means sweeping and dusting regularly
– once a week, at least, and after any event that leaves dirt
and grit behind. Regular household dusting and cleaning products
will cause damage, however, and you must use only products specifically
designed for hardwood.
Vacuuming is preferable to sweeping because it allows the dirt
and dust to be pulled from between the boards, but use a vacuum
with a bare floor attachment, not a beater bar, which can damage
When a more in-depth cleaning is required, use a cleaning method
appropriate to the finish on your floor.
If your floor has a glossy finish, it means that polyurethane,
or a water-based urethane, or a similar finish has been used to
form a protective barrier over the hardwood.
If it has a matte finish, it means that the floor is protected
with a penetrating seal of oil and/or wax.
On neither of these finishes is water an acceptable cleaning
agent, but both of them can accept a surface, damp-mop cleaning,
which means the mop is not wet but only damp to the touch. You
are cleaning only the surface and not using enough water to penetrate
even the oiled-and-waxed hardwood. When using a damp mop on oil
and waxed hardwood, you can add a little neutral ph hardwood floor
cleaner to the water before dipping the mop into it.
A floor with a protective glossy barrier can accept a generic
hardwood floor cleaner providing it doesn’t contain any wax or
The don’ts are every bit as important as the do’s in hardwood
1. Don’t use ammonia, regular floor cleaners, household cleaners,
or dusting products on hardwood.
2. Never use wax on a floor with a urethane or other glossy
3. Never wash hardwood; use only a slightly damp mop.
Repair Any Damage to Your Floors as Soon as Possible In most
cases, when your oil and waxed hardwood floors have suffered surface
damage, you have to remove the finish with a wax or oil stripper
before dealing with the damage.
After completing the repair, you then re-wax or re-oil the area.
Surface damage occurs less often on hardwood protected by polyurethane
or a similar type of sealer, and when it does, the damage is not
When repairing floors with such finishes, strip the finish from
the entire board or boards where the damage has occurred. Make
your repairs and then apply a finishing product to those boards
that is consistent with the rest of the floor.
1. Water marks: Remove the protective finish, rub the marks
with fine grade steel wool. Repeat if necessary, clean, and then
2. Burn marks: Lightly sand the area, use a damp cloth to pick
up the grit, and then refinish as desired.
3. Scratches and gouges: Conceal shallow scratches with matching
wood putty or a putty stick. After the area is dry, sand and refinish.
Refinishing Your Worn Hardwood Floors Will Recapture Their Original
Beauty and Value
In a home with shabby hardwood floors, the biggest improvement
you can make is to refinish the floors. Begin by making any necessary
repairs, and then removing all the furniture and drapes and sealing
the vents and registers in the room so that you won’t spread dust
throughout the house.
Sanding floors is easiest to do with a drum sander and an edging
machine for the sides and corners of the room. You can rent these
machines, and it is a good idea to rent a buffer or floor polisher
at the same time. Plan to make three passes with your sanding
equipment, using increasingly finer sandpaper each time. Vacuum
carefully and pick up every bit of fine dust and grit with tacking
cloths. All dust and dirt must be removed.
You can now apply a stain if you wish or you can leave the natural
color and design of the wood – such as the popular oak, maple,
or cherry – to be displayed. Polish and clean the dust and dirt
from the floor again, and then apply your sealer – a polyurethane
or a water-based urethane that provides a protective barrier,
or oil and wax, which penetrates the wood and protects from within.
Carefully read all the information accompanying each product,
follow the safety advice, and apply as many coats of stain or
sealer as suggested by the manufacturer of the products you are
Hardwood Floor Care Means Providing Ongoing Floor Protection
As well as regular cleaning, and repairing and refinishing when
necessary, there are a number of protective measures you can take
to preserve the beauty of your hardwood:
1. Use area rugs and mats in high traffic areas and sites of
frequent spills (e.g., in front of the stove, sink, and refrigerator).
Move these rugs frequently so that these areas of the floor remain
the same color as the exposed floor. As well, it is best to choose
cotton mats as they do not trap water under them as rubber or
2. Keep high-heeled shoes in good repair and avoid using stiletto
3. Keep nails trimmed on pets.
4. Clean up spills immediately with a paper towel or dry cloth.
A damp cloth can be used for sticky spills, but dry the spot immediately
afterwards with another towel or cloth.
5. Lift rather than drag furniture when moving it and use felt
contacts under furniture legs to prevent scratches and gouges.
6. Use sheers or blinds to protect your floors from the discoloration
caused by direct sun rays.
With proper care and maintenance, your hardwood floors will
retain their beauty and enhance any décor that you choose. When
your floors become worn, or if they become damaged, they can be
restored to their former glory with a little time, effort, and
Use the Internet to check out quality products, read the information
on how to use them, compare prices, and place your orders. We
can help with all your hardwood floor care needs – everything
from discount hardwood flooring to hardwood cleaners – and all
items can be purchased online and delivered to your door. Let
us help you keep your hardwood floors looking their best.
Scott Gray is currently freelance writing and
enjoys providing information and moneysaving tips to consumers
who are in the market for hardwood floors, hardwood floor care
and hardwood flooring articles. Article Source: http://EzineArticles.com/
Coronet Carpet Sources at Carpetnetwork.com
... Related terms are atlanta floor hardwood, antique ceramic tile wall, carpet remnant, carpet in michigan store, and beautiful begins flooring us. Here is a brief overview of carpeting styles to help ...
bruce hard wood floor
... care for hard wood floor how to clean wood floor how to install wood floor how to restore wood floor install hard wood floor installing hard wood floor installing laminate wood floor installing wood ...